Electric / Hydraulic Towed Vehicle Brake Actuator

Sorry we do NOT ship outside of Canada

BrakeRite Electric / Hydraulic Actuator

The BrakeRite Electric / Hydraulic Brake (EHB) System by Titan is an electric over hydraulic braking system using electric power from the towing vehicle electrical system.  As the brake pedal of the towing vehicle is depressed and the brake lights come on, the BrakeRite EHB system is activated when the towed vehicle brakes are applied.  The electronic control package inside the BrakeRite EHB is turned on by the signal used to control the pressure as sent from the in-cab electronic brake controller (sold separately 74-90195).  This pressure is maintained on the towed vehicle brakes until the towing vehicle brake pedal is totally released.  It is very important that the driver NOT RIDE THE BRAKE PEDAL as this causes constant drag on the towed vehicle brakes and will cause the towed vehicle brakes to prematurely wear or overheat.  Actuator can handle up to 4 axles.

A breakaway kit (sold separately 74-034-285-00), to be mounted on the trailer, is also required to supply electrical power in the event that the towed vehicle becomes uncoupled from the towing vehicle.  The breakaway battery must have a minimum capacity of 12 volt, 8 amp.

The system relies on electrical power from the towed vehicle.  The system requires 12 volts DC with 14 gauge wire and 18 gauge control leads.  The power draw is 16 amps @850 psi and 23 amps @ 1,500 psi.

The BrakeRite EHB includes a Charge Protection circuit that is included to  prevent a surge charge causing damage to the battery.  A blocking diode is also included in the circuit to prevent the towing vehicle from drawing power from the breakaway battery.

Click for Manual

Electro/Hydraulic brake actuator for 1-3 axles.  Brake fluid pressure is proportional to the electronic brake controller signal.  Sealed, anodized aluminum housing provides a weather tight seal.  Two year limited warranty.

• 1,000 psi maximum pressure output for axles equipped with drum brakes (67-K71-650-00)
• 1,600 psi maximum pressure output for axles equipped with disc brakes (67-K71-651-00)
• Dimensions: 11.38" long x 6" wide x 7" high 
• Requires a four wire hookup and minimum 9 amp/hour break-away kit (sold separately 74-034-285-00)
• Uses DOT 3 or 4 brake fluid, holds 40 cubic inches (0.7 quarts) of fluid
• Meets all DOT regulations and complies with CFR-393 federal braking requirements, as opposed to surge brakes
• Eliminates the feeling of being "pushed" by the trailer (reducing the potential of jackknife)
• Eliminates the problems found when backing a trailer uphill with surge brakes
• Eliminates brake drag common with surge brakes on a downhill grade

Click for Manual